...hi from Greece! i have a clio 172 ph1 and i 'm tuning it up for 210+ for a single throtle body.
at last with green air induction kit , custom 55'' full exhaust decat and remap (7800 lim.)it was running 155whp.
now i have all belong parts and next week we will start the JOB!
full port of cylinder head
port and polished inlet
wossner 12.8:1 orged pistons
forged con rods with arp's from engine dynamics
engine dynamics cams set (the profile colombo bariani's) but mines will be refaced for a litle more torque low rpm
mls head gaskets
new followers
cat cams valve springs
arp head stud kit
Bottom End gasket and seal set
trimetal coussinets (balance with crank, rods etc)
haltech E8 ecu system with lot of options and extras
compression about 12.9:1
and i'm thinking about ptfe inlet gaskets
then after 2-3000 miles of low rpm running we will fit a 182 manifold with a 2.5'' custom exhaust and we will programe it on road and dyno.
do you think that with these mods 210+ is a ''dream''?
have any one to suggest something? what about a larger throttle body or port the oem mody?
what about ttv light weight flywheel?
thanks George
at last with green air induction kit , custom 55'' full exhaust decat and remap (7800 lim.)it was running 155whp.
now i have all belong parts and next week we will start the JOB!
full port of cylinder head
port and polished inlet
wossner 12.8:1 orged pistons
forged con rods with arp's from engine dynamics
engine dynamics cams set (the profile colombo bariani's) but mines will be refaced for a litle more torque low rpm
mls head gaskets
new followers
cat cams valve springs
arp head stud kit
Bottom End gasket and seal set
trimetal coussinets (balance with crank, rods etc)
haltech E8 ecu system with lot of options and extras
compression about 12.9:1
and i'm thinking about ptfe inlet gaskets
then after 2-3000 miles of low rpm running we will fit a 182 manifold with a 2.5'' custom exhaust and we will programe it on road and dyno.
do you think that with these mods 210+ is a ''dream''?
have any one to suggest something? what about a larger throttle body or port the oem mody?
what about ttv light weight flywheel?
thanks George