Search results

Hi everyone, my 05 clio 182 60k is having trouble starting, it starts but occasionally it dies instantly. To add to this recently the engine has cut out whilst driving a number of times, I have noticed this to happen when braking and engaging the clutch the revs just drop and the engine cuts...

I have a nilfisk C125.3-8 pressure washer which is stated as having a 520L/hour flow rate. Also using an inch of AB magifoam topped up with warm water to just under half of the 1L bottle and the resulting foam is pretty useless, majority of it running off within seconds down the road and...

I know this has been covered before however I haven't seen the valeo fast road clutch mentioned, would that be worth the extra £30 over the standard valeo clutch? Also what are people's thoughts on lightened and balanced flywheels? Worth it or not? Any help would be great

Had cooksport springs fitted in April along with new shocks all round, now on my 2nd set of front cup shocks and they are beginning to fail, squelching when going over bumps in the road is unbearable. Anybody else experienced this with cooksport or sportline springs?

The knocking noise follows the alloy wheel, if its on the front the knock happens at the front and then moves to the back if I put the alloy on the back. Alloys are 2118s, and I just can't figure out why its doing this as they are only about 6 months old and I always avoid potholes so they...

http://www.gumtree.com/p/cars-vans-motorbikes/renault-clio-182-cup--39500-miles/1004645920

Anyone know the O.E part number for an SMI rack? Thanks

Had this for months now, when rocking the steering left to right only 5 - 10% past centre each side Im hearing and feeling a knock/clunking through both footwells. I've replaced all with new parts, tie rod ends, ball joints, top mounts and now new steering arms and its still there. Also...

Anybody know where I can get the inner tie rods for the SMI rack, need to be approx. 335mm?

Quick question, are these sold as a pair or single? 120 on their site, does that buy a pair or just one? Thanks

Fitted 15mm fk hubcentric spacers about a month ago, passenger side front spacer came loose on Sunday night so I bolted it back on and ever since then I've been getting bad wobble/vibrations through the steering wheel when I go over 50. Any idea what could be causing it?

I have a janspeed cat back exhaust and the joint between the back box and centre section keeps blowing because the back box twists, I put a new clamp on the joint recently however its started to twist again. Do I need a whole new cat back system?

I know this is really happening as my dad is a member of the team at 'ACE' and has known about it for a while now, but the news has only just been made official. New EU roadworthiness package – causes consternation in many car circles! New EU proposals are likely to make it impossible to use a...

Had my tracking done today as it was way out when the bloke showed me, he then showed me when he said it was finished and it was 0 on the front right and 2 on the front left. I was thinking it should be 0 each side or has he done it right?

fitted my FK spacers yesterday and noticed the car drove horrible straight away then a knocking started. Took the spacers off today and noticed that my alloys (2118s) dont sit flush against the face of the spacer, the hubcentric taper does not match the taper on the wheels. Anyone had similar...

As the title suggests, are there any differences other than the ITG being £20 more expensive? Thanks

The car starts up fine from cold but then when I get to the end of my street and stop at the junction with the brake and clutch pressed the car will rev slightly like Im feathering the throttle. This stops once the car has warmed up abit, just wondering if this is normal or I have a problem...

At the moment my clio has 17" alloys and lowered 15mm rear and 20mm front on eibach pros and I am suffering with my tyres rubbing on my front archs when cornering. So Im looking at 16" turinis or 15" 2118s both with a change of springs to eibach sportlines instead of pros. Just wondering if I...

Will they fit without any rubbing issues?

Thinking of buying them but alot of the pictures ive seen of them on cars they have not got any centre caps, do they come with centre caps or do you have to buy your own from speedline?

About 19:55 tonight, parked outside franky and bennys. Anyone off here?

I am buying some new alloys and the ones I want are 16", 7.5J, offset between 20 and 25. My question is will I have any problems with these size alloys rubbing anywhere on my front arch as this is the reason why I have to buy new alloys in the first place? Thanks.

When I bought my clio 182 the previous owner has lowered it but I dont know by how much. Is there any way of finding out or measuring how much it is lowered? I know the springs are Eibach cause its stamped on the spring Thanks.

I have rubbing issues on my tyres and was told to check the offfset of my alloys, the offset is ET 42 and I was just wondering does that mean I need spacers and if so what size? Thanks

When I lock my clio 182 it sometimes gives 3 beeps, not every time though I would say about 20% of the time. Just wondering if anyone knows what this is? Cheers

My car is lowered by either 15mm or 20mm at the front with eibach springs and the tyres are rubbing on the arch lining, making a mess of the outer edge of the tyres and wearing a hole in the arch lining. Just wondering if anyone knows how I could stop this without the obvious solution of...

Hi all, bought my 182 cup nearly 3 weeks ago. Its a 182 Cup with lux pack, with turinis and recaro seats that you find on the trophy model. Its in blue and has done 28,000 miles and is in amazing condition inside and out, I just love it and it is now my pride and joy! Will be posting a few pics...