Recent content by jammygit

My iPhone, brand new and has the factory seal on the phone. http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=140417537868&ssPageName=STRK:MESELX:IT#ht_500wt_1154

Yeah it's got the newer style sport badges too which I definately like :)

My car is soo dirty :dapprove: the C L I O badge was on it when i bought it and i didn't like it then either but it has grown on me now. 1.2 looks even smarter in the flesh :approve:

Lambda Sensor: http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=140408939665&ssPageName=STRK:MESELX:IT#ht_500wt_1182 Part worn: http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=140408937705&ssPageName=STRK:MESELX:IT#ht_500wt_1182

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=140408747621#ht_500wt_1182

Saw you last night, i was in a championship white DC5. Car looked nice, seemed pretty low :)

like the sound of £10 a corner :) and i think i will measure the arch gap with the 1 inch lips they have already and see what is possible once the centre bore is sorted.

I will be putting new lips on and as yet haven't decided which width to go for. Possibly 3 inch for the rears and a smaller maybe 1.5 or 2 at the front. Was considering putting the mark fish lowering springs on too if i can get hold of some to make the wheels fill the arches a bit more.

Yeh the offset is et 33 which is already going to come out quite a bit as its on a trophy which is et 43. Adding the 20mm spacer to that will cause me problems. They are BBS RM wheels, a lot will probs say not because turinis are almighty but after seeing a set with red centres and chrome lip...

I am looking at a set of wheels that are VW fitment (4x100, 57.1 centre) What is the easiest/cheapest way to get these to fit ? H+R do 20mm adaptors but for all four wheel is going to cost about £210, would i be able to get the bores machined out for less than that ? or is there another way ?

I made it for a bit in the trophy, few nice cars there when i got there; R26R, V6 and some MK1's Commitment to the french car cause :)

T33PHY and a mates astra when the snow started last night :) (please excuse iphone quality :rasp:)

That looks exactly the same as what I'm using and it doesn't seem wide or deep enough to effectively clamp the flange on the centre section to the decat. Think I will give the heavy duty ebay one a go, worth a shot for a fiver.

Sounds good, never seem to be many RS clios when I normally go :( 1. Meganelady 2. Jamesev 3. Brian (maybe, will confirm nearer the date) 4. Dansmotorsport 5. Vdust182 6. Telfords_Lurk (maybe, will confirm nearer the date) 7. Coral (maybe) 8. Keef (maybe) 9. Lora (will check my shifts at work...

Last night the exhaust clamp (fitted by kwik fit) connecting my decat to centre section fell off :( I put another one on today the same as the last one but it doesn't seem to fit very well. The exhaust is a BTB system and the flange is quite small so it doesn't tighten up too well. Are...