Recent content by stann01

THIS

changed both rear discs as bearings fooked + took some skin off finger :mad:

i got a poly bush and put it in the old hanger ready when the one on there fails!!

i think he means because the exhaust is not being held by the bolts you need 2nd person to hold it , and the other to do the bolts

so it might be best to take it to the local garage and tell them to do better job this time and fit ALL the parts i give them!!! (this is the garage that said i got a one off engine and differant gearbox on the car that it should have lol)

the one i can get to had a job trying to undo the old nuts and it just sheared off!! was hoping to do the same on the left one but its in such a tight place cant get to it. was thinking just use my long screwdriver and levy it till it breaks but then i got a job to get new nut on :-(

is it possible to do from under the car? looking at it the heat shields are in the way ?

hi, i got the dreaded tank noise accelerating on my ph2 172 :dapprove: bought the kit but cant get hands or tools on left bolt (looking from front of car) got plenty of rash too on hand from the fibre glass thats near the job :mad: now pretty cheesed off with the whole job and thought i would...

i went down yesteday and the chappy got the shaft out that they got for it, said this is whats sposed to fit my car, said i got a totally differant gearbox to whats sposed to be on car!! today i got some pics off k-tec website of both new shafts after getting call to say the car was ready and...

best bit is they said the gearbox has got all the wrong bolts in holding it on!

think you are correct. just been down there to see what the feck is going on, he now says he is getting cv boot from renault and is going to take my driveshaft apart and fit it that way!! thats all they had to do in the first place duh. he also said they had renault techs out who confirmed i...

hi guys, got a major problem getting my 172 through the m.o.t. it failed on outer and inner cv boots on one side, its in an independant garage, and they said need to replace driveshaft. looking into things on here it had been said its easier to do it that way. had a ring from the garage to...

hi all, done the required test to bridge the connections 1 and 5 and the heater comes on full so guess its the resistor where can i get one from? scrappy maybe? dont want to pay renault silly money had a looky on fleabay but they only have refurbish service

yeh it was a little 5amp :) all working again