Snet Track Day Media

[Greeny.]

Went to Snet last night for the evening session, great fun, best the car has gone, videos of a couple of the sessions below, I don't pretend to be the best driver but I was making progress as the night went on

In session three, after I was getting wound up being stuck behind things a cheeky Type R with carbon galore cut down the side of me and the two cars I was trying to get cleanly past, anyway after catching him up he lost the rear end down the start finish straight and caused a red flag :/ No idea on damage as I left after the red flag, the spin is at the end of the first video below.

IMG_1678 by danfullstop, on Flickr

by danfullstop, on Flickr

 

[imprezaworks]

Great vids mate. Car sounds good, what's the spec?

 

[Greeny.]

Great vids mate. Car sounds good, what's the spec?

Roughly: Matched Inlets, Janspeed Supersport Cat-back, Homemade Induction Kit, ex MSV Caged Rear Cage, Air-Con Delete, BC Racing Coilovers, RSR Tyres, RSTuner Remap, Fully Stripped

The better mods to do on a limited budget Would love ITB's or something serious but I could buy another car for less

 

[imprezaworks]

Good stuff. Track looks good too, never considered it as its bloody miles away and I'm lazy lol

 

[Greeny.]

Good stuff. Track looks good too, never considered it as its bloody miles away and I'm lazy lol

Its my 'local', just over an hour away so not to bad, back there in Aug for a full day :smile: Only issue I had was boiling power steering fluid, took some out and all good after! Car went really well, im far from perfect around it but learning as I go, didn't have an issue getting past most cars apart from the properly quick stuff.

 

[imprezaworks]

Did you find fitting matched inlets an improvement mate?

 

[Greeny.]

Yup, worth doing tbh, I did mine myself as I have an RS lower inlet which are 'ok' out of the box but worth getting them both done on a 172 as only late ones normally have RS stamped lowers.

 

[imprezaworks]

Easy enough to do? Was tempted by a set but never bought them

 

[Greeny.]

To match? Yes I just carefully used a dremel for the top, the bottom is more fiddly to get off but the same applys.

 

[imprezaworks]

Yeah to match. Not looked into them before but if not rocket science to fit I may keep an eye out

 

[massiveCoRbyn]

What colour was the Civic out of interest?

 

[172_Tom]

Car sounds really nice and goes well

Have you tried heel n toe? I practised it while stationary before trying it out while moving and it wasn't as hard as I thought it would be.

 

[Greeny.]

Car sounds really nice and goes well :smile:

Have you tried heel n toe? I practised it while stationary before trying it out while moving and it wasn't as hard as I thought it would be.

Cheers

Yes and failed, not attempted it since

 

[Greeny.]

What colour was the Civic out of interest?

Grey with carbon everywhere.

 

[Greeny.]

MSVT Pics from the evening:

CH_150715_SN_MSVT-4032 by danfullstop, on Flickr

CH_150715_SN_MSVT-4058 by danfullstop, on Flickr

CH_150715_SN_MSVT-4060 by danfullstop, on Flickr

CH_150715_SN_MSVT-4090 by danfullstop, on Flickr

CH_150715_SN_MSVT-4126 by danfullstop, on Flickr

CH_150715_SN_MSVT-4134 by danfullstop, on Flickr

CH_150715_SN_MSVT-4155 by danfullstop, on Flickr

CH_150715_SN_MSVT-4168 by danfullstop, on Flickr

CH_150715_SN_MSVT-3984 by danfullstop, on Flickr

CH_150715_SN_MSVT-4030 by danfullstop, on Flickr

Dan

 

[Cub.]

Looks good, and going well

 

[massiveCoRbyn]

Grey with carbon everywhere.

Finally got round to watching the video. Yep, that's the guy I suspected it might be...