Hey guys looking for some input on a potential issue, below is my yet unanswered email to ktec racing:
Morning!
Recently received a Miltek system from your selves. Removed old exhaust yesterday and I'm going to fit new exhaust today.
I built the exhaust up off the car first; to check the components for fit, condition and what not.
I'm a little concerned about the small adaptor flange that goes between the cat and the middle section of the system. Whilst it mates to the cat fine, it seems too small in diameter to properly sleeve into the middle section. Instead of sliding in with no room to spare (like the back boxes connect to the middle section) there's a good 2-3mm of play between the surfaces. I can't see how clamping these pipes together will produce a proper seal?
Looking for your input based on your experiences with these systems. Many thanks in advance,
Mark
P.S
I can provide pics, if desired, for clarity.