Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
I've looked through a few previous threads about adjusting the torsion bar but did not find a great deal, Im pretty handy with the spaners but have never even looked at adjusting a torsion bar is it a easy job, what tools will i need?
M10 threaded bar, preferably high-tensile. I usually use a headbolt.
A nut to fit, a 30+mm socket, plenty of washer.
Put the socket over the bar, a 30mm sits nicely on it to give loads of space, put the nut on the bar/bolt, along with a few washers, then wind it into the bar, then use the nut to wind the bar out.
I assume you meant where it was located previously? Theres no point tbh. If you are handy with a set of spanners then it's a piss easy job as long as its not seized.
I assume you meant where it was located previously? Theres no point tbh. If you are handy with a set of spanners then it's a piss easy job as long as its not seized.