Milltek catback & decat, how do i go about refitting my cat?

[ontheway]

The decat pipe fits inside the milltek exhaust, how do I go about re-fitting a standard cat without modifying the cat itself?

 

[jesus]

The Milltek comes with a little attatchment which allows the above. Did you not get one?

 

[ontheway]

I bought the car with the exhaust fitted, however I have been lent a cat by a member on here. He also gave me a small fitting pipe (about 4" long) with a flange on one end that appears to fit between the cat and my exhaust however i'm unsure how I actually attach it to the cat?

 

[1812lsd]

One of these.

 

[jesus]

Is it similar to the little piece in the centre of this picture?

If so, that will make it like a standard join that will fit the cat.

As standard, the join like the one above (slotted onto the middle section) would meet up against the cat and an exhaust clamp like the one below would keep them together.

 

[ontheway]

Cheers guys! I'll see if I can pick up a 64mm clamp tomorrow