ClioSport.net

Register a free account today to become a member!
Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

  • When you purchase through links on our site, we may earn an affiliate commission. Read more here.

J&R Drivers side Driveshaft



  rstuned 182ff bg
Morning Chaps, Just a quick one , My 182 BG has been in the local garage now for a fwe months, New clutch / two new driveshafts , Passengerside a shaftec and the drivers side j&r shaft, MY question is do i have to grind the little square nobby bit off on the gear box, ?.Due to j&r driveshafts being a bit fecking shite, I am due to pick the clio up next week. I would of bought a shaftec for both sides , but i couldn't find a shaftec for the divers side at the time, But in the next few weeks i'm gonna try and grab one.....Cheers for any info lads.
 

Lozza-p

ClioSport Club Member
  BG FF 182
is it a cup/cup pack?

If so J&r ones don’t fit they are too short
 

Crayola

ClioSport Club Member
I've had 2 Shaftec ones for the offside of my 172 and both of them have had the inner boot come away from the cup, subsequently spraying grease everywhere

I told them to shove it up their arse and bought a Borg and Beck one for half the price. It's been spot on! I had to grind off the little square casting from the block but other than that the fitment is mint
 

Lozza-p

ClioSport Club Member
  BG FF 182
The lad at the garage said he's been for a drive in it, So i'm a bit puzzled with the j&r shaft meant to be to short.
Maybe mine was boxed wrong then. it was about 10-15cm shorter, i emailed them with pictures and they just said that's the only one they list
 

MLB

ClioSport Club Member
I've had 2 Shaftec ones for the offside of my 172 and both of them have had the inner boot come away from the cup, subsequently spraying grease everywhere

I told them to shove it up their arse and bought a Borg and Beck one for half the price. It's been spot on! I had to grind off the little square casting from the block but other than that the fitment is mint

I'm can't find any o/s driveshafts for my 182, is this the item you used?

Looks like a non cup abs ring, but assume I could just put a 15mm cup one on there.

 

MLB

ClioSport Club Member
Picture looks like 8mm ring. But for that price I can't complain.

Much less complaining than when cleaning cv grease off the wheel, wheel arch and suspension. Twice.

Also now finding out it's all in my hair because I stuck my head in the wheel arch to check where the hole in the cv boot was😂
 

Mr Underhill

ClioSport Club Member
Picture looks like 8mm ring. But for that price I can't complain.

Much less complaining than when cleaning cv grease off the wheel, wheel arch and suspension. Twice.

Also now finding out it's all in my hair because I stuck my head in the wheel arch to check where the hole in the cv boot was😂
Says in the description 44 tooth. As you say, you can always fit one
 
  • Like
Reactions: MLB

Crayola

ClioSport Club Member


Top