not mine, had my RS stamped ones enlarged all the way through slightly too. :approve: Depends where you get them done mate. Had mine CNC'd throughout
hmmm, they're not 45 degree, they are pretty straight when you look down them. the plenum on the other hand was only done about 4cm in.
Can some 1 please tell me the diffrence between a Stamp RS inlets and a set of matched ones and are the Rs 1s any good??
They're not straight. The angle is close to 90 degrees in fact. When you have had them machined through+through , it was'nt done by cnc/machine.
I am talking about the lower one ofcourse; this has the RS stamp on it. Or not.
The upper one does'nt have the RS stamp, the one you seem to talk about ?