MG ZS180 Mk2
I think this has been covered a couple of times but need a little more info.
I am trying to run a fairly thick wire from the battery to the boot but I am having problems.
I managed to do this on my 182 using the main electrics route near the passenger footwell but on the R27, it seems to be a lot harder to get a wire through. There is a big plastic rim to the grommet and then the bonnet release and electrics run through the middle of it.
I spent about 30 mins trying to poke a smaller wire though into the engine bay so I could then tie it to the bigger wire and pull it back through but I think all I done was coiled about 1m of wire into the bodywork somewhere as it didn't come out.
Its like trying to push smoke up a cats ar5e with a knitting needle :S
Any suggestions as I would like to have another go tomorrow.
Cheers
I am trying to run a fairly thick wire from the battery to the boot but I am having problems.
I managed to do this on my 182 using the main electrics route near the passenger footwell but on the R27, it seems to be a lot harder to get a wire through. There is a big plastic rim to the grommet and then the bonnet release and electrics run through the middle of it.
I spent about 30 mins trying to poke a smaller wire though into the engine bay so I could then tie it to the bigger wire and pull it back through but I think all I done was coiled about 1m of wire into the bodywork somewhere as it didn't come out.
Its like trying to push smoke up a cats ar5e with a knitting needle :S
Any suggestions as I would like to have another go tomorrow.
Cheers
