182 wheels on a valver?

[Craig]

do the 182 cupped alloys fit on a valver.

thanks

 

[Da]

Well the PCD is correct so yes, however I'm not sure if the ET would be an issue as I don't know what a Valver runs standard.

 

[Spark]

wont 16s be too large for the valver arches

 

[Craig]

doesnt matter now lads thanks

 

[cat171]

^damm
I was hoping to see a pic of a valver with them on it as i've not seen that done before.

wont 16s be too large for the valver arches

Not really, you can get 17's on them without that much work. I've seen valvers on mk2 172 alloys, but they need spacers etc to fit.

 

[CODGEY 182]

I had 17s on a my first valver and never had a problem it was dropped 60m too.

 

[dangerous dave]

they do fit, might be a bit tight to the rear arch with passengers and on full lock.. ..

 

[White16valver]

Valver standard offset is ET37.5 or 38 I think.

 

[clioGT]

think that 172 wheels is the best choice

 

[Anonymous]

I had 17s on a my first valver and never had a problem it was dropped 60m too.

ditto

 

[BigChris]

old school faces on here... how you do mukkas?

 

[S7HXX]

They need spacing, I had some on mine for a while and they were fine on standard suspension just looked whack as they sat inside the arch too much.

 

[Daniel]

They look really good!!

 

[S7HXX]

I prefer the wheels in your avatar, are they polished Williams wheels?

 

[iimushroomzii]

They look better than I thought! Spacers, sorted!

 

[Daniel]

I prefer the wheels in your avatar, are they polished Williams wheels?

No mate, just powdercoated silver.

 

[Mells]

That looks sweeet!