What's new
By:
Filters
ClioSport.net

Register a free account today to become a member!
Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Search results

  1. E

    High compression Piston

    Is it possible to buy a single high compression piston and PEC con rod ?
  2. E

    Omex 600 femal terminal size ?

    Can anyone give me the size of the Omex 600 female terminals or a link to purchase them ?
  3. E

    Any difference between Phase 1 and phase 2 flywheels?

    Need help guys, is there any difference between a phase 1 and a phase 2 flywheel? Having problems with flywheel sensor picking up the flywheel positions unless I lift the sensor a few millimetres. Only thing we have done is change the flywheel.
  4. E

    Dephaser Solenoid wiring

    Does anyone know how the dephaser solenoid is activated? Is there a circuit diagram, is it operated from a relay ?
  5. E

    Engine Compression Test OUT of car ???

    Can I do a compression test on an engine which is sat outside of the car ?? If so how ?
  6. E

    HELP needed CLIO lower manifold to head Bolt size and pitch

    HELP needed CLIO lower manifold to head Bolt size and pitch , The seem to be M8 but they are not the standard 1.25mm pitch anyone can confirm what they are please.
  7. E

    Remote Brake fluid Reservoir - Whats required ?

    Looking to move the fluid res , whats required ? What size fittings go into the Master cylinder ? what hose should i use ?
  8. E

    How to minimize coolant temp sensors using OMEX stand alone instead of Piggyback .

    Using OMEX 600 Piggy back with ITBs and currently using 3 Temp sensors. One used by Omex engine management , one used by Standard ECU to operate to operate standard Temp Gauge and electric fan, and One used to operate a separate Temp gauge. Ideally I would like to get down to ONE sensor that...
  9. E

    Clio 172 rear coil overs Reinforcement ??

    Planning to fit rear coilovers to our circuit race car . Do the top mounts need reinforcing ?
  10. E

    Race car Dash - What are you using?

    What do 172 / 182 racers use for Race ? track dash
  11. E

    Clio 172 running Omex 600 - will it run the Rev counter ?

    Currently running a 172 Race car only. Omex 600 currently runs engine. We have bypassed Immobilizer for Fuel and Omex. Can we get the omex to run the standard 172 Rev counter ?
  12. E

    How to paint side of Headlight Blank using standard light lenses, what paint , what prep ?

    How to paint side of Headlight Blank using standard light lenses, what paint , what prep ?
  13. E

    182 What size is this bolt ??? Rear caliper , carrier fixing

    Need new bolt for rear caliper to carrier for 182 . Any ideas what size it is as my Renault dealer says it is not available on its own.
  14. E

    Alarm problem

    Help ? when i open the car i can get in but as soon as I turn the ignition it sets off the alarm. What can I do ?
  15. E

    What Compression Readings on F7R 16valve ?

    Anyone know What Compression Readings would be good on F7R 16valve ?
  16. E

    Clio Williams 1 Rear Ride Height Problem

    This is probably a common issue but tried searching forum and not found what I need. I have a Williams Clio 1 -2.0 with uneven ride height at rear, can someone advise two things please 1) Standard Ride Height, 2) How to adjust it?
  17. E

    HI all Fotum Members, New Clio Williams Owners.

    :pHi everyone, I am the proud joint user of a track day Clio Williams 1. My son and I did our first track day with the Williams at Donnington in October 2013 and we were not let down by its performance. This was the first time I had been on track for 35 years but my son had been on track days in...
Top