Recent content by wingy23

Poss carbon canister, have a listen in the drivers side wheel arch

Re: 172 mk1 knocking (hard acceleration and over bumps) Renault Swin say that cant f Hi i had this on my 172 and it turned out to be the gearbox mount under the bat have a look it could be badly worn. My bolt was also worn that goes through the middle

Welcome to cs

Looking good mate keep up with the up dates

hi mate tryed to pm you but you cant receive them but yes that is the same as mine even down to it picking up when you pick up the revs let me no how you get on with it and ne more props give me a shout thanks

hi mate ive got a 172 and ive got that tappin took me ages to work it out it was the cerbon cannister if you can get to it you will feel it tappin. it is behind the front bumper on the drivers side you can get to it if you undo the bolts on the wheel arch liner and pull it back

hi and welcome to cs

hi mate just wonderin if i could have the details for your warranty so i can look at gettin it for my car thanks

if you can find a clio with manual ajuster you can change them over and do away with all the crap

hi mate ive played with a few of them it could be cable or it will be air poperaited so if there is a split in the pipe ne where it wont work and it mite suck water in from the road if you cant get it workin you should be able to pull the ajuster out abit to get the aim up or push to get it down...

hi mate it sounds like the verable valve timing was not set up properly it would of been ok for a few miles but then it would of gave way and done a valve or two i would get back on to the garage that you had it done at and get them to sort it out and dont drive it ne more

1. Jaffa182 2. whatisjustis 3. John.med 4. Cupster 5. Clairemae 6. 182kev 7. martynrg 8. kevin.s 9. CupDude 10. koi 11. xzibit 12. Bash 13. Chrisjk 14. MadHops87 15. Nigel 16. Roy Munson 17. Sean Blakey 18. RRTT 19. 182laney 20. Pete_Cup 21. The Stig 22. Weebaws 23. J88NES 24. martandem 25. Mr J...

if it has not come uncliped there is a ajuster on the back of the headlight i think you can use a phillps skrewdriver or a 5mm alan key so if you park the car about 2 foot away from a garage door or a wall you can lower the high headlight to the same as the other one you will see the patern on...

thanks for the welcome guys

thanks mate i mite do that when is it on? Where is it?