Recent content by Laine_16v

You'll have issues with the clutch before the gearbox.

Check the other one isnt stuck in your cylinder head :)

1/2" BSP to AN10 adaptors (most likely), you will need to use a different sandwhich plate for a temperature sensor, as the one pictured doesnt accomodate one.

Had a similar sort of thing this Summer myself that i remember. In slow traffic on the M4, continual 40-50mph cquite congested no ones getting anywhere quicker than the next person. I am alongside and in the near region of 8 pikeys, all with transit tippers bareing their typical tree surgeon...

Well considering they only work upto 10-11psi (i think), 99.999% will just be using wastegate actuator pressure to control boost.

Meggy pistons are a pure lottery for reliability imo.

Yeah unfortunately the box was out of warranty period (it was done iust under 2 years ago). One cannot argue that the synrcos should not crunch on the first drive with the oil grade recommended by him (75w-90, but i later tried 75w80 after with no diference), somsomething was clearly not right...

Thought it was about time i gave this a thread revive. After the alternator failed last year i decided to take the car off the road, and in true typical clio turbo ownership its been off the road in parts ever since! Purcashing my own pad knocked my finances sideways and the car was definately...

YOu would think so yes. I am using a normal Mocal plate and stat (not an ebay billet job). But the SPA oil temp gauge just shows it doesnt reach temp adequatley. SO either its a faulty thermostat, or the thermostat naturally never fully closes and has a small bypass allowing a small amount of...

Wish i got 12k form my helix, i didnt even see half of that :tonguewink: Sachs clutch looks interesting, but will it do 360ft lb?, im guessing unfortuantely not :(

I've got a 13 row cooler @ 400bhp. It's of course thermostatically controlled, but it still cools toooo much, used to struggle to get it over 75 deg even when driving hard. I've now fitted a slideable cover on the front so i can cover 50% of it for everyday use, then uncover it if needs be on a...

I made it out of a piece of 2mm sheet ally. I actually spent quite a few hours on it and a did a nice job of it (pic doesnt do it justice). However since i've had the engine out its dissapeared into thing f****** air, guess ill have to make another!

My iceberg cup turbo

My pressure switch is like below for my SPA gauge, i did use a 1/8" BSP to 1/8" NPT adaptor rather than to just wind it straight in and hopew for the best.