Recent content by jimbob200

That sounds about right to what I read but also saw you can replace the relay rather than adding a resistor??

Sorry if this has been covered I did look and couldn’t find a thread. I have just fitted some LED bulbs and I went to fit the indicators and the flash runs at a much faster rate seemingly due to the difference in power usage, apparently best thing to do is replace the relay with one designed to...

Possibly? I I have a feeling this is the culprit

Ktec, don't think it's map as was fine for 1.5hr drive home, I then fitted the induction kit and removed the flappy sensor thing

Mk3 200

Hi all, Picked up a ktec induction kit yesterday and fitted it last night, drove to work fine came to leave work and got a check emissions message. I did remove the sensor from behind the passenger headlamp as I thought that's what was done? Is this my issue or have I done something else...

Afraid not me buddy, used to have 205's but never a mini

Ideal thank you!

Got this info for the mk3 by anychance looking at 20mm or 20.5mm front ARB bushes from powerflex

This is what is throwing me....

Hi guys, So I have a 59 plate clio 200, I have replaced the suspension so I came across the pre 09/2010 difference with suspension meaning mine shares the suspension from the 197. Now I am looking at exhausts and have come across the 60mm/63.5mm exhaust sizing now my question is what is my car...

Did you fit an Oreca in the end?

One nut on the bottom of the hub, steering and driveshaft?

hey guys so just been fitying my new b14's to my Clio, and I have trashed a pinch bolt (pictured below I hope) and wondered if anyone has a part number to save time. Also out of interest how do you get the hub low enough to free the shock?

hey guys, Looking to fit a front splitter seen a couple and someonementioned on a Facebook page about a focus st splitter fitting nice... In short what are the options and how easy are they to fit etc, pop up some pics of what your running..... (judging by the Facebook comments I can't be the...