Recent content by ericd2477

Is it possible to buy a single high compression piston and PEC con rod ?

Can anyone give me the size of the Omex 600 female terminals or a link to purchase them ?

Need help guys, is there any difference between a phase 1 and a phase 2 flywheel? Having problems with flywheel sensor picking up the flywheel positions unless I lift the sensor a few millimetres. Only thing we have done is change the flywheel.

Do you know which wire is which on the solenoid earth ?

Does anyone know how the dephaser solenoid is activated? Is there a circuit diagram, is it operated from a relay ?

Thanks guys, decided to do both tests . Had to put gearbox back on to mount starter motor. Will use jump leads to a battery and exciter wire.

Can I do a compression test on an engine which is sat outside of the car ?? If so how ?

HELP needed CLIO lower manifold to head Bolt size and pitch , The seem to be M8 but they are not the standard 1.25mm pitch anyone can confirm what they are please.

Looking to move the fluid res , whats required ? What size fittings go into the Master cylinder ? what hose should i use ?

It's a greased rack not fluid

I thought that, is the 1.2 heat shield similar to the 172 ?

Another question, when using the DCI rack is it necessary to fit the heat shield ?

Will have to contact OMEX to see if it is supported

Just found in the installation manual for the OMEX that any temp gauge needs a separate sensor on the engine side , Looks like I am stuck with 2 sensors

Want to ditch the standard ECU. So if the OMEX will run the fan thats one sensor gone. still have two sensors one with OMEX and one with standalone temp gauge.