ClioSport.net

Register a free account today to become a member!
Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Recent content by Ryanph1rs

  1. Ryanph1rs

    Polishing and Sealing Re-furbed Alloys

    250 hours is usally fine before polishing etc
  2. Ryanph1rs

    Scratched Glass

    3m do a good glass compound http://www.polishedbliss.co.uk/acatalog/3m-glass-polishing-compound-cat16.html but its not cheap its good for the odd wiper mark but anything beyond a fine surface scratch as jd said its a new window.
  3. Ryanph1rs

    fiesta st 180

    Ahhh see now this is interesting, i think im going to speak to ford on monday and see what they say, my discs are all scored and just not like youd expect and that no one else has had fade is interesting. i did have a bit of an accident with the handbrake not holding properly and it rolled into...
  4. Ryanph1rs

    fiesta st 180

    Mine are not very good at all sadly, well there not that bad but still for 12,480 miles id expect them to be alot better mines a 13plate so i don't know if ford might of had an early batch of pads that are a bit pants? I drive mine rather gently in the week as i commute 30miles to work to save...
  5. Ryanph1rs

    fiesta st 180

    Hello, so after along time of selling my clio ive got my self a rather nice fiesta st 180 to drive everyday, however its in need of new brakes all round as the standard are shocking after only 12k! goes any one have any recommendations? Is G still doing brakes ? at the moment the big £1000...
  6. Ryanph1rs

    updated engine mounts experienced opinions please

    There solid if i had any fillings they'd be gone :) if you leave a can of coke on the seat go for a drive then open it , it can prove to be interesting.
  7. Ryanph1rs

    updated engine mounts experienced opinions please

    Ive got the red vibratechnics ones .... there hard .. really hard in fact its like driving a washing machine on spin cycle the whole ting vibrates and rattles and there is even a rattle for the rattle its bad.... that being said theve dramatically improved the feel of the car when on b roads ...
  8. Ryanph1rs

    Fitting rear cage?

    both seats out, 2 people are needed really .... tilt cage back front feet up by dash, 1 person either side of car and carry it through, then push it back into place and give it a few firm taps to get it in nive and tight :) mark holes to drill ... remove cage and paint it tidy :) ... then refit :)
  9. Ryanph1rs

    help and advice about ph1 engine conversion please

    or if its for a sleeper look just swap the bumpers over.....
  10. Ryanph1rs

    help and advice about ph1 engine conversion please

    are they the same colour? ...... could just swap the plates over itll be just as illegal as I assume the reason youre converting is to avoid the high insurance .....
  11. Ryanph1rs

    gear box after turbo ?

    megane box sounds good.... I know a lot gets asked over and over but this ive not found any one say,..... so and so does the conversion they charge X amount and supply all the bits drive in drive out..... nor have I heard any one say anything other than use this and its ££££££££££ money...... I...
  12. Ryanph1rs

    gear box after turbo ?

    seems that 300bhp is along way off.... whats the charger kit cost you is it worth it over the turbo ? 250bhp would be okay id like to see close to 280 tho really fancy having something thatll embarrass m3s and stuff :) ... had a mk2 xr2 with a zvh turbo conversion before was just so much fun...
  13. Ryanph1rs

    gear box after turbo ?

    suspension and brakes are sorted but the gearbox and engine is the big $$$$$$$$$
  14. Ryanph1rs

    gear box after turbo ?

    ouch ive seen a few threads about the 02m box, don't really think I can justify the money as my clio needs calipers ( and as ive gutted it completely it needs a carpet and a dash) my gear box atm is like a stick in a bucket ( even with the pms kit and solid mounts all round ) so im like hmmm 2k...
  15. Ryanph1rs

    gear box after turbo ?

    Hewoo, im thinking about going down the turbo route, im looking at the 4k kit that andy offers but my gear box at the moment could use a refurb so im wondering what options do I have as im sure the standard one couldn't handle the power, id like 280-300 bhp and as much torque as I can have :)...
Top