fitting cold air feed / removing old air feed pipe

[cup182 racing blue]

was wondering is it ok to remove the air feed sensor? seen this when i had my bumper off the other day and its in the way of fitting a cold air feed pipe if i remove will it make lights come up on my dash? thanks

 

[Eckascliovalver]

shouldnt do mate, mine is off and everything still works fine

 

[cup182 racing blue]

did you unbolt the whole thing where the horn sits?

 

[SCOTT_182CUP]

I took mine off just leaving the horn down the bottom so I could run the cold air feed from the front lower grille. All still running ok so you should have no problems

 

[MoRpH3uS]

No probs for me either !

 

[D1CKY]

Remove it, its caused me no probs.
And its called an acoustic valve
Just remember to tape up the electrical connector with electrical tape to stop s**t getting onto contacts and tie it up out of the way.
Also block off the vacuum pipe with a screw or similar (just slightly bigger than pipe) or your idle will be all over place