Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Just to close this out, if anyone else sees similar codes etc.
I used garagepro on android, it can read ABS, connected to a bluetooth OBDLink adapter.
C1001 is the drivers front ABS sensor
C1010? I guess is passenger front
C1020 passenger rear
C1030 drivers rear
The other codes C1111 & C10E1...
Hey there,
Had these lights appear months ago on my '04 Clio 182, they would disappear after driving for a while then they became permanent fixtures i.e. they are on as soon as I start the car.
So far I have ...
- Changed passenger front ABS sensor
- Checked & cleaned sensor plugs
- Checked...
Hi guys
Almost a year since my last post. The Clio went through its MOT last year with no advisories, so resealing the exhaust, new mounts and cat to manifold kit helped fix the leaks.
I’ve been using the Clio as my daily, but left it sitting over the whole of xmas. When I started it back up...
I managed to get the starter motor heat shield back on tight. I wrapped the starter cables with electrical and heat resistant tape.
I had to loosen up the exhaust manifold to head bolts, a 3/8 joint socket was needed to get at some of the bolts.
That gave me just enough room to get the heat...
MOT pass with no advisories!! Just went for a spin down some country lanes and one big difference I noticed is there is absolutely no roll when you throw it into a corner.
I’ve got the standard cup springs and dampers and it did roll quite a bit before fitting the arb.
Anybody have any tips on...
Drove down to the MOT centre and first time I’ve driven it with the white line ARB, feels really tight and nimble.
They are having fun revving the nuts off it, the Scorpion sounds good. The last MOT it had failed because of exhaust leak, I pulled the whole thing out last year and replaced...
Hoping to get the Clio out next week, will post an update then.
I resprayed the rear quarter today, my first effort was a little thick on the primer. Sanded it back and tried to blend with the existing paint as best I could, better than my first attempt but still not great ?♂️
I’m liking the...
Its been over a year since i touched my clio, finally got some free time last week so got the front bumper painted matte black. The original paint is black gold, but I think the matte looks alot better.
The battery didnt last through winter, and didnt respond to a recondition, so fitted a Yuasa...
Couldnt get a decent spray on the front bumper, so ive taken the bumper off and going to repaint the whole piece. Ditching the spray can too and getting something that i can control the spray better. Also found why my headlight washers arent working, leaking hose. May just get washer blanks and...
Thanks mate. Repairing the bodywork aint too bad, just needs alot of patience to get it smoothed out. The painting is a ball ache, especially with a spray can. Too much pressure and left with drip marks. Once im done though it should be looking alot better