Recent content by Spence_12

Thanks Steve, I'll have a look at that area this week and try and give it a clean up. I've got some IPA electrical contact cleaner spray so hopefully that might do the job.

Ok thanks. So would that essentially be check the abs rings and clean them up along with checking the condition of the sensors and associated wiring? I've already checked the white plug for corrosion and cleaned up any I could see on the pins. I guess there could still be corrosion on them...

I guess so. I'm guessing that was meant to say codes? If so it brought up a code for throttle position sensor circuit A coherence between track 1 and track 2, and also one for the brake switch. With regards to the wheel speeds he drove me round the ground outside the garage at slow speed with...

The abs light came on a couple of times over the last few months but always went away when the ignition was turned off and on again (a couple of times I could feel the abs kicking in at low speed). The abs has now been on constantly for a couple of weeks and is on regardless of the limp mode...

For the last few months my 04 182 has been going into limp mode very intermittently with revs capped at 3000, but absolutely no pattern to when it happens. When the fault occurs the engine light is on but there are no other lights on the dash bar the ABS light (which i believe is an issue for a...