Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Injectors all mesure 14ohms on my meter. Obviously this is less than the 15 that it should be but its a £30 meter and all injectors measure the same across the board which I'd say is the important part.
Who said anything about ignoring the codes? I've unplugged each injector which each time has caused the car to misfire far worse that it did before leaving me with the impression at the time of the injector working.
The reason I said I'd check the O2 sensors is because when googling I've come...
I've seen a couple of folk saying O2 sensors so might as well try it but yeah if expect a specific code for that.
I tried all disconnecting all 4 ht leads and injector plugs individually because the ones at the timing end made the car run rougher so didn't seem to be the issue. Removing each...
Thanks guys. I knew the French numbered them that way but it had went totally out my mind so thanks for that Steve! Anyway the same still applies as I've swapped plugs round all cylinders and disconnected all the injectors, individually of course.
O2 sensor was my next port of call but that...
Hi, Looking for a wee bit of advice, I've got a 182 which has a very slight miss fire on idle, car drives fine but comes up with p0301 cylinder 1 miss fire.
Ive tried new leads, coil and swapped the plugs around, miss doesn't change cylinder when doing this. I've done a compression test and...
as some of you might remember i have centre exit exhaust which looks s**t and im skint so i cant replace it just now :dapprove:
would i be able to cut the tailpipe off (after the silencer) for now?at least it would look better.
cheers
ermm..cos it looks nicer
how is it the same as putting 2.0 badges on? if you put turinis on a 1.2 does that mean you want it to look like a cup?
al:how much did the grille set you back?