Recent content by philfree

My contribution: Received the adapters really quick, very good job done by Jon in designing these adapters! Clio doesn't feel like driving a delivery truck any longer, seating position vastly improved and very easy to install. If you want to feel like having more control and want a racing bucket...

Unless you're OK to cut a small section in the top and bottom half cases (because of the protrusions for the screw each side of the lens) and rotate the lens 90 degrees. The flex cable might be a little short then (not sure) but 5cm extension is available that can fit in the case. There should...

All you need to know about the mobius is here: http://www.rcgroups.com/forums/showthread.php?t=1904559 For setup and firmware update use the GUI app mSetup here: http://www.rcgroups.com/forums/showthread.php?t=1904559 Have fun!

Spax damper adjustment doesn't work on one side, one damper stays on soft pulling on this side under braking? Edit: Never mind, didn't see you swapped strut which made no difference

Can't you get them direct from Renault Sport, they list at €188 exc.VAT 7711155603 but get a quote first, RS site says 2012 price list...

Take the wheel off and take a look at the other side... This side is easy as they can (normally...) see what they're doing, the other side may be worse...

There's no answer to that. Any 15" wheel will fit providing you use thick enough spacer to clear the inside rib and have the caliper sit in the increased diameter pass the rib. Then, you can as I did grind the top of the caliper to clear the rib (I use 5mm thick spacer to clear the spokes and...

Yep

Make the 33mm height from this drawing 31mm

Exactly 11mm needs to be 11.8. As for the 5mm, this design puts the mounting face 18.5mm away from the bolt center (33-14.5), if you do it like shown, it will translate to 7.5mm machining on the calipers. 7mm should be best as the dimensions I gave above may put the pads just a tad below the...

There's no definite answer. Caliper needs to be machined 5mm if height from bracket fixing bolt center to caliper mounting face is 16mm. If height is 18mm for instance, caliper needs 7mm machining. Most ready made bracket will be 16mm though so 5mm need to be shaved off the caliper. Caliper...

Don't know if your pictures are your latest fitment but you pads retaining pins are not seated properly, they should protude a lot more on the pointed side to be secured.

They may fit as your wheels will be a lot farther away than mine. You may just need a little filing of the caliper or just machine an addtionnal 2mm off the caliper seating faces or a little bit of both.

If you use original disks, the edge of the pads should be just above the outer edge of the disk but it does not really matter as it will only be 1 or 2mm above, it would be spot on if you use 282 or 283mm disk and drum. This is why I gave my measurements cause not all adapters are made equal...

Well.... NO. Projection of the adapters fixing screw holes and the caliper fixing bolts intercept. The distance between the screw axis and the Brembo seating surface is 21mm on the 300 adapter which leaves enough meat to thread a hole and use a bolt (21 - 6 (half a M12 screw) = 15mm of thread...