Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
I checked that. I was going to adjust it but found it could not be adjusted so I physically bent the bracket a little but didnt seem to make much difference.
I always brim it then use it to do the same again. Back end does not feel anywhere as sure footed as my Williams :/
This looks awesome. Not a lover of the LY inside tho. Finally a 197 with the engine it always should have had :)
If your using it as a daily what sort of mpg are you getting?
I think these springs are 30-25mm drop. Would anyone want to swap the rears at all? They only a month old.....
I'll take a couple more pics tomorrow to show how it sits. The fronts have gone down another 10mm but the rears are as they look in that pic above.
I dont want to adjust the headlights u want the rear lower. Once its the hight I want ill adjust the headlights if I need.
Just need to know if anyone has cut a little bit off the rear spring? Im guessing it will lower it another 20mm on rear.
Hi all. I fitted my lowering springs the other month and they did feel ok. Now the fronts sit nice but hard and the rear is too high and soft..... I was thinking to cut half a turn off the little pig tail on the rear springs. Anyone else done this? My headlights are pointing to the floor so I...
Wrote the RSTuner stage one map to the 182, cold start is loads better and does tick over better. Had to buy the Performance map tho :dapprove: this should come with the RSTuner as standard in my opinion.
Hmmm, I've been on the fastchips site and its looking that they want an extra 49 euro for the 98RON overrun map.....
I bought the RSTuner new with the impression that you could choose what map you wanted. I've been sent the OEM 97 RON map that I cant get to work anyway.....
I'll not spend...
Iv clicked on download and it saves wherever it should but its not the map I want and I cant load it to the bloody ecu anyway. Iv probably ballzed something up. Ill uninstall the lot and start again at this rate.
He sent me a couple of YouTube vids but they were of no help due to the map file not being present.
So got to wait till tonight for reply. Im at work now so ill be up to pester him until I get the map I want.
Iv no fault codes to show.
The email Henk sent does not show up in the "write cal" option.
How do I download the map I want? Do I need to email fastchips again? I cant seem to find what I want.
Iv had the unlock cod3 sent then another email with a zip file with the othe map but I WILL NOT load? Iv message Henk last night at 3am and he just forwards YouTube vids.
Iv watched the vids and all that comes up is my original Calibration map not the new one. Pissing me off now. Gotta wait...