Recent content by DanClio182

Same! Should be as easy as jacking the engine up a bit? Do you know the torque setting for it?

Looking forward to giving it a shot once i figure out which one i need. Although im not an expert this looks easy enough to do.

Tempted to do the RS tuner myself, people speak highly of them. Just need a laptop!

How much did the RS Tuner set you back? What version did you get?

Recently had a look at it, turns out the rack mounts were quite loose and wasn't fitted correctly by one of the previous owners.

Over a couple months a creak/snap has appeared mainly when i dry steer. I recently installed lowering springs and new top mounts as they were both gone. Any help would be appreciated.

My 182 is hesistant when cold. Every morning ive got to sit for a minute or so until the revs sit below 1K otherwise or it will feel hesistant if i pull straight away. I also have a misfire code appear occasionally when im idling either in traffic or on a cold start. When warm, it runs fine.

Have you got an email mate? Having problems uploading on here.

No, it should be between the the back of the engine bay and the engine itself.

Beat me to it! Mine was just kinked, all sorted and sounds normal. .

Recently my top mounts have started to creak an awful lot at slow speeds whilst turning. Also when drying steering, ill get a loud almost snap as they are turning which can be felt through the wheel which im guess is the steering rack? Ive recently purchased some lowering springs and will be...

Just removed the kinked pipe. Noise gone. I have a k&n induction kit, the pipe comes off it at an angle hence it kinking. Need a braided hose. Dont suppose you know the size i would need? Cheers!

It could be several things. Compressor, expansion valve etc. Id imagine most places would just replace the whole system. Turn your system on, open up the bonnet, you'll see your A/C pipes on the left side entering the drivers side. Set your settings to the lowest setting and give it a couple...

I have yes, but id put my money on it that it's not that. Although i have got an induction kit fitted and the breather pipe is kinked... I have a nice oil leak from somewhere aswell, think thats the rocker cover.