ClioSport.net

Register a free account today to become a member!
Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

  • When you purchase through links on our site, we may earn an affiliate commission. Read more here.

Rear pad fitting..



  Nothing at the mo :(
Anyone got a guide on these? I tried to search in the guide section but it wont load after i click search :S
 
  330i. E30 Touring.
Just pads?

Loosen wheel bolts.
Jack rear up and put on stands (with handbrake off!).
Remove wheels.
Remove metal clips that hold pads in.
Tap slider out with hammer and screwdriver.
Remove two bolts that hold caliper yoke.
Everything will fall off.

To fit, reverse procedure.

You'll need to wind the piston back in with a flathead screwdriver though.
 

Martin_172

ClioSport Club Member
2 bolts to remove the rear pad carrier, pop it off, pull out the pin that holds the slider in place, tap the slider out, pads will come out, new pads in place, tap slider back in, pin back in, wind back the caliper piston with a flad blade screw driver, re fit calliper.

can be done in 10 minutes!
 
  260% JCW
Also may help to take the lid off the brake reservoir, makes it a bit easier when winding the piston back in.
 
  Nothing at the mo :(
omg how long have you been on this forum ;) At the top of the guide section Fubar has done a few guides. One of which is brakes. If that doesnt help, then i've done one too;

http://www.cliosport.net/forum/showthread.php?394322-FubarNet-Guides

http://www.cliosport.net/forum/show...nes-and-handbrake-adjustment-on-182&highlight=

There you go flower :)

Fok ive been here a while now.. and i actually looked in fubar's bit.. must of just completely missed it lol.. cheers bud
 
  Westy. MX5
As you will have all the brake dis-assembled don't forget to give them a good clean, wire brush and brake cleaner will help.
 


Top