Search results

Right. Getting the scenic shifter sorted but seems to be so many opinions as to what works best! Have ordered Yanoo's stiff shift 3.0. My plan was to bend the shaft slightly and extend the base section to shorten the shift. Yanoo recommends fitting the 15% quickshift and shortening the linkage...

Hi folks, will be modding a scenic shifter shortly and a friend has offered to turn a wee link piece up on his lathe for me to extend the lower shaft. Anyone know the inside/outside diameter please? He works at sea so will sort it out on board for me- problem is I don't have a spare to...

Might be in the wrong section so sorry if so. Got someone interested in my seats but not sure of the best way to send within the UK? Anyone got any suggestions? Sending from Glasgow to York..

Hi folks. One for the auto electricians here possibly. Have bought some lovely mk1 Audi TT seats to go in my clio. Still have airbags in them and was wondering how hard it would be just to wire in/solder the connections so these theoretically would work. I'm no auto-electrician (as you've prob...

Changed to a decat and am getting massive vibrations at low revs- top engine mount is moving quite a bit and the bolt on the cam cover section nearest bulkhead has threaded. Got a replacement cam cover bit that hopefully has good threads- is it easier just sourcing a bolt that's a few mil longer...

Hi folks. Decatted the above exhaust and it's fekking loud. Vibrations are bad especially at low revs which may be due to the evol lower mount but it wasn't that bad before I put the decat pipe in. I've made sure it's well sealed, no obvious leaks. I know these exhausts are fairly loud but I'm...

Read on here recently that someone was doing basic ECU remaps by post on a swap basis but can't find the post. Have tried search and Google. Can anyone help?

Going to see a 2006 1.4 dynamique tomorrow for a family member. Done 71k and apparently in good nick and gearbox fine. Apart from usual stuff like uneven tyre wear, dodgy electrics and shonky panel gaps anything I should look out for? When is the timing belt on these needing done for instance...

Anyone I'D this seat? Been offered a pair for a bargain price..

Normal light braking, just as I'm about to stop abs kicks in for the last couple of feet. All sensors and rings are fine, no error codes. New front disks, pads and bled properly a short while back. Garage is a bit stumped tbh. Anyone got any ideas?

Seems a bit bizarre asking but looking at various budget replacement seat options.. recaro trendlines etc look good and obv Jon Fox has subframes to suit but there's lots of Focus ST type folding recaros that seem to come with airbags fitted at reasonable prices. I realise that some later clio...

Got a budget of between 2 and 300 quid. 2004 182, 105k miles, has recently had all belts done water pump etc, new brakes and fluid, new tyres. So prob going to.have a few hundred quid to spend on general improvements.. I'm thinking- New front cup shocks- £90 renparts New rear shocks £45 eBay...

Went to change the discs and pads and the first one I've taken off has not t45 screws to hold the disc on. The nuts obv hold the whole thing on but will I die if these are not fitted?

Hi folks- fairly newish here but have been taking good advantage of the guides and classifieds! One problem I've had i with a lot of photos being posted not showing when I click on threads- screenshot attached- It's a bit of a pain when I'm looking at a guide or an advert.. I have a photobucket...

So have done my reading on here, tried replacing coil pack, leads and plugs with the proper ones- still have slight misfire on idle, map sensor working ok, got a basic one reader that detected a misfire on cylinder 2 so replaced the injector. Still idling rough/lumpy. Took it to an ecu...

As per above- pointing downwards.. is this probably a problem with the infamous fragile adjuster in the headlamp that I've heard about? Is it a relatively easy fix if so or is there an outside chance it's one of the level sensors- either front or Back? Cheers.

Changed the head unit from standard to a Bluetooth one I had. All went well then realised the passenger door speaker isn't working. Only got the car recently so may have been like that already but not sure. Is this a common problem? Should I start at the speaker end or take the stereo out again...

Taking my wheel off and when removing have pulled the red and black horn wires from the squib. Not had the squib out yet and aware problems with the horn wires are common but is it easy enough just to solder them back on? Will I need to remove the steering angle sensor from the squib to do so...

Hi folks. I've tried searching but can't find a "how to" to replace the gearstick with a newer replacement. It's a 182 and just a straight swap- not sure if im just not using the right phrase or words in the search fields. Can anyone help? Ta.