Commie VID
ClioSport Club Member
Elise 111S, Model 3
Hi all,
Mucking around with the car, and have taken off the front wheel arches and bumper to see what lurks underneath. I'll need replacement front wheel arch bits to the bumper, as they're both in different states of destruction.
When putting the bumper back on though, there is a gap between the front wings and bumper at the edge, you can push the bumper up to align it but it just goes down again. The spire nut and bolt for that area only seems to attach the bumper to the chassis, not sure if it is meant to connect to the wing too. Does anyone else have this problem? Can't seem to figure out why. Only affects the end of the bumper, the rest snaps into place as expected.
Mucking around with the car, and have taken off the front wheel arches and bumper to see what lurks underneath. I'll need replacement front wheel arch bits to the bumper, as they're both in different states of destruction.
When putting the bumper back on though, there is a gap between the front wings and bumper at the edge, you can push the bumper up to align it but it just goes down again. The spire nut and bolt for that area only seems to attach the bumper to the chassis, not sure if it is meant to connect to the wing too. Does anyone else have this problem? Can't seem to figure out why. Only affects the end of the bumper, the rest snaps into place as expected.