Recent content by shauncr91

There's a chap around Hoyland with an LY200 but can't remember if it's FF or Cup.

Spotted on Manvers way around 8:15 today. Gave me a quick honk of the horn as he pulled away..can't be that many LY 200's knocking about?

Dropped it off for a new front spring and ball joints at the dealer, thankfully under warranty!

I've had a few made up by Halfords in the past and not been able to fault the quality with any of them. Expensive though.

I'd just go ahead and drill it. I had OMP frames in my last car and the holes were also out of line slightly also.

If it moves back or forth then that's fine, I'm just worried about disconnecting it and the engine dropping slightly as that would be more difficult to sort!

Hi guys, Just ordered this as I find the engine movement way too much in my 200. Is this particularly difficult to fit? Do I need to support the engine at all or can I just go straight in and unbolt the original mount then switch the bushes over? Ta

Just found this on the official RenaultSport forum and it was a guy who diagnosed it to being ball/swivel joints. Hopefully the garage doesn't mug me off and say it's a consumable item considering I've only had it 2 days!!

I had a similar noise on my Fiesta ST a long time ago however it wasn't as loud and that ended up being bad ball joints. However from the reading I've done on these Clio's and the racks being a nightmare I wanted to know if this was a symptom of rack failure or potentially something else! It...

Hi guys, I picked up my 200 Cup on Friday and it's making a screeching noise occasionally under very slow/dry steering. Has anyone else had similar can point me in the right direction please? Video of noise: Thanks

RickyRPM in Barnsley has done a couple now.