Search results

I have spent the last couple of days reading about clutches for low boost... It's a mine field, I read posts on here and on Facebook and there seems to be no correct anwser... Many people say standard is ok then it goes over to last 500 miles definitely needed... Then it gets worse when going...

The 2 piece 300mmx 28mm discs For the 4 pot upgrade.. I notice they are a bit lighter and assume they are good quality but is there any other benefit from using them as they are twice the price of decent normal ones..my front discs are about half way through I'm wondering when they done should I...

What's involved in doing this? Would it be safe ?

Could have pics of where people put there boost gauge. Not sure if I want a pillar pod or many in a vent. Any ideas ?? Thanks

Keep getting sent the wrong one need a rear left abs sensor sensor for a 172 with esp Thanks

Decided that I'm going low boost turbo going fit myself ( well hover about while my m8 does it) I seen Ed do a complete kit sbworkz do one that 600 cheaper thou it don't come with ecu, Chris at efi does the ecu and mapping for 550. Is there any other options I have ? My car has the sm inlet...

So i was intent on buying a brand new car to replace my 159 and bought an e46 m3 instead (my wife approves shock horror) So I have some funds spare and decided that I will spend them on the worlds most unreliable clio I already have an old shogun I use for off road so no more room for cars...

Say my centre section was split front and back on the box enough that I can feel the hot air come out cause a loss of power ?

Just had my car mapped at efi and the crusie no longer works Crusie and limter lights up but it can't select speed with buttons No fault with lights abs esp and Speedo all work Any ideas ?

The world's most unreliable clio strikes again. Got a p0500 fault, speed sensor fault but my esp abs and Speedo all work fine. Only thing is I can turn my cruise on but can't set a speed but the car has just been mapped and I'm sure after I had an rs tuner map done before I had to reset the...

Had a search but nothing recent about winter tyres. I have proxies atm and they are awful in the wet, Was thinking rainsport 3s any suggestions

I just bought an sm inlet. Anyone have an advice before I fit it and recommend a decent mapper, I live in scotland but would be willing to travel. Thanks

Got myself a set of trendlines with omp subframes, but the passenger one won't recline, only seems to unhook from one side, Can this be fixed if so how ?9

Im about to purchase a set of recaro seats out a 182, they are the same as in the trophy. As part of the deal I have to swap my standard seats, Is it a simple swap over, or will I run into problems ??? Also how do I get rid of airbag light ?

My car is pulling to the left, The tracking is strsight its just had a fast road setup along with new tyres, ball joints, bearings steering rack bushes Coilovers are fine top mounts and trackroad ends are 5 months old, Any ideas I can only think its the rack ???

My rear caliper is sticking, gonna replace it ? Are they only for the clio or can I use a megane, twingo etc one ? Thanks

So I fitted coilovers driveshaft and ball joint on drivers side along with a set of rotas, tracking was well out so had it done and the car wanders at speed feels very unsafe. The tracking was done and was spot on. The car is fine when turning no wobble or vibration No play in steering arms they...

If you look in the pics the drivers side is alot higher only noticed because drivers side knocks sometimes, I put back together as per guides.

I have an 04 non cup 172. What drive shaft length do I need and is it one or two piece ? Im sure the the inner part is bolted to the bock, its drivers side Thanks in advance

Eml light came on twice in a week been 1500 miles since decat. Going to try a spacer, there is short, long and one at angle. Which one is best ? worried about not being enough space. Also is it m18x 1.5 thread ? Thanks

Doing weekly checks I noticed the aux belt had moved too rings off the pas pulley, The aux kit was done less than a month ago and the belt is bowstring tight and I put tipex across crank pulley and thats not moved, garage thinks it might be pas pump but it makes no noises even on full lock Any...

Anybody know where I can get one or have a part number thanks ?

Noticed a squeak on startup when cold/wet It's coming from the crank aux belt pulley I also noticed the rubber on it is slightly cracked so going to have it changed. Is there any advantage to the solid lightweight ones and does anyone have a part number for the original part none on eBay Thanks

My aux belt is sqeaking for a minute or so when cold starting, its a new power gates aux belt and kit fitted a weak ago searched on here no definite answer battery and alternator couple of months old

Where is best place to get one all the searches are old ?

I been searching and answers range from its awesome gives you 8bhp to total waste of money.most of the threads are 6 years old So what is the deal do matched inlets really give more power ? How good is the rs inlet over standard and is diy matching worth a try or should it be left to the pros...

Does a 2004 172 have canbus steering control I'm trying get steering controls for a pioneer head unit don't know if I need CTSRN004 or CTSRN005 I have a 5 pin yellow mini ISO ?

Can someone Photoshop my wheels black and gunmetal\dark grey please can't decide what colour to get. Also if my dog was doing a poo that would be cool aswell Thanks