Good Evening All,
Firstly apologies because I am sure the info is in this forum but I have searched hard and can't find a definitive answer.
In short, the clamp between the CAT and centre section of my Milltek exhaust failed. I believe what I need is an Olive Clamp, can anyone confirm?
Secondly should there be a gasket that sit between the two sections?
& Finally does anyone know what size clamp I need for a Milltek Exhaust system. I think its 69mm but if anyone can confirm it would be appreciated.
Thanks in advance, Sam
Firstly apologies because I am sure the info is in this forum but I have searched hard and can't find a definitive answer.
In short, the clamp between the CAT and centre section of my Milltek exhaust failed. I believe what I need is an Olive Clamp, can anyone confirm?
Secondly should there be a gasket that sit between the two sections?
& Finally does anyone know what size clamp I need for a Milltek Exhaust system. I think its 69mm but if anyone can confirm it would be appreciated.
Thanks in advance, Sam