Recent content by Stueylouey21

Just got project cars on PS4... looking into getting a wheel/pedal setup. What do most people go for without spending stupid money?

Ok cheers for the help!

I'm guessing disconnect battery before cutting ? And just cut off the plug from the new seats and solder wires together, but how do I know which colour wires from the car go to which wires on the seat?!

I'm currently in the process of removing the front seats from my 172 cup and fitting the half leather seats. Got the bolts undone no problem but just need some help with the wiring! Do I just cut through the wires? And what do I need to connect back onto the new seats? New seat

It's more the damp that's bothering me tbh, had a look at the seal around the rear passenger window doesn't look great. and top corner of windscreen has peeled up a little. Are these easy to fix?

Cheers for the links, and yeah has been sitting on driveway for a couple of months already. Probly be sat for a couple more while I get it sorted for mot. After that it will be more intermittent use I guess and will use it when I get the chance!

Looking for some advise/ideas My car rarely gets used at the moment since getting a new company van. Looking for advise on best ways to store the car avoiding common problems. Ideally the car would be sat in a garage but I don't have acces to one. Im looking at getting a decent cover? Any one...

Def not tyre pressures.. But I'll be honest my car really doesn't get used much atall these days. Having said that MOT time is coming up very soon so I need to give the car a once over so may have some more info soon!

Cheers bud, that gives me plenty to have a look at! Hi mate, not really had a chance to have a look yet! I don't use the car very often now as I have a work van so the cup gets left on the drive :( I will have a look myself this week and if I get no where pop it into a garage to get it looked...

Oh and I do have the oil filler cover painted the same but left it at work!

So I've made a start, gone from completely standard to this so far.... Painted engine cover (wasn't sure whether to put this on or not!) fuel rail cover and inlet.

I have now made a start! Will post pictures tomorrow of how's it's looking at the moment, will probly take the inlet back off and clean and paint the rocker cover as didn't really take much notice of how much you see it until I started painting other bits!

Well this is going well.... Lol

Just stripped off the upper and lower inlets and the fuel rail gaurd ready for cleaning and painting! Looking for ideas/inspiration on inlet colours and engine cover colours (or leave engine cover off?!) Looking to tidy the whole engine bay so.... Show me what you've got!

Would the power steering pump make the squealing noise as well? Or could it make the belts slip? Can you bleed the system to get rid of air locks?