Switching from KTR Ultra performance to Janspeed Sports Exhaust - HELP!

[siburrman]

Hi guys,

I currently got the KTR ultra performance exhaust (Straight through mid pipe and de-cat) and have now got a Janspeed sports exhaust (silenced mid-section and Cat). As they are the same company i thought i could just take the cat and mid-section from the Janspeed and put it on my KTR Ultra back box - But it turns out the Janspeed has a 2.25 bore and KTR has 2.5 so they done fit.

So what i want to do now is swap out the whole exhaust system. The KTR comes with a special mount on the back box (Ive circled this on the pic below):

[IMG][/IMG]

When i try to put the Janspeed backbox on this mount doesnt fit. I have no idea what was supposed to be there before this mount. Can anyone point me in the right direction where i can buy an original mount to fit the Janspeed exhaust?

My second question is to do with the connection between the CAT and the mid-section. The end of the CAT fits snug into the end of the Midsection but theres nothing holding it in place (DECAT PIPE went all the way into the mid-section) and feels like its going to fall off. Should there be a special clip holding it in place? If so can someone show me where to get one? The one from my KTR system was just a exhaust clamp which doesnt look like it will hold the CAT and midsection together - i have added a pic of the clamp below.

[IMG][/IMG]

[IMG][/IMG]

Any help would be great, want to get this exhaust system on my car.

Cheers people

[martin182]

you need one of these for the cat to centre section joint.

http://www.ebay.co.uk/itm/RENAULT-CL...9#ht_678wt_905

[siburrman]

Cheers mate, will buy myself one.

I had a look on a standrad hanger on the internet and found this:

[IMG][/IMG].

Can anyone confirm if this is a standard hanger i need:

[Dan@519Automotive]

that is standard

[siburrman]

Thanks Dan.

Anyone have this spare? Going to try a scrappy later.

My bolts connecting the downpipe to Cat has also snapped. These one ebay look the correct set but its for a PUG:

http://www.ebay.co.uk/itm/2807003272...84.m1436.l2649

Anyone know if this will fit?

[Edges]

Cheers mate, will buy myself one.

I had a look on a standrad hanger on the internet and found this:

[IMG][/IMG].

Can anyone confirm if this is a standard hanger i need:

Thread revival!!! Does anyone have a part number for this hanger?? just bought one from Adam at Renault and it's arrived but is far too small to fit on the studs under the car. Wrong part I presume!!